Everpure ScaleStick (EV9799-02) (EV9799-42)

Application 

- Water-Using Equipment

- Steamers

- Combi Ovens

- Ice

- Coffee

- Espresso

- Proofers

Features & Benefits 

- Features Hydroblend™ compound, a unique blend that inhibits mineral scale deposits and provides a corrosion protection in low flow water-fed equipment

- Patented design dispenses a controlled amount of Hydroblend™ for long term protection and provides greater effectiveness than standard phosphate treatments

- Translucent cartridge allows simple visual monitoring of product usage and ensures against wasteful premature cartridge replacement

- Integral feed cartridge fits most standard 10" housings

- Unaffected by high temperatures, the SS-10 cartridge accomodates a wide variety of applications

- SS-10 cartridge fits all current SR-X housings and all existing old style AR-X housings

Sizing

- Service Flow Rate: 0.1 - 6 gpm (0.3 - 22.7 Lpm)

- Capacity: Approximately six (6) months.

- Capacity will vary depending on application and water usage. On flow rates less than 1 gpm (3.78 Lpm), capacities may be reduced

Operational Tips

- Deliming of equipment prior to application is recommended but not required.

- Inspect ScaleStick® cartridges at least every six (6) months.

- Replace ScaleStick® before Hydroblend™ compound is completely dissolved.

- Pre-existing equipment scale may come loose and clog equipment.

- Remove any loose scale to assure satisfactory operation.

Installation Tips 

- Housing not included. Fits standard 10" housings.

- Order Model A-10 clear housing (EV9100-01) for temperatures less than 125°F (51.67°C)*.

- Make sure selected housing fits temperature and pressure conditions.

- Install vertically with black O-band seal up.

- The SS-10 ScaleStick® cartridge cannot be installed into filter wraps.

- Flushing is not required for ScaleStick® cartridges.

Specs

Service Flow Rate:

- Maximum 0.1 - 6 gpm (0.3 - 22.7 Lpm)

Capacity:

- Approximately six (6) months. Capacity will vary depending on application and water usage. On flow rates less than 1 gpm (3.78 Lpm), capacities may be reduced*.

Temperature:

- Maximum 150°F (65.5°C)* If inlet feed water temperature is above 125°F (51.7°C) a hot water housing must be used.

Overall Dimensions:

- 10.062" L x 1.312" D (25.5 cm x 3.3 cm)